A high-capacity 3S pack for models that draw serious current — 7000mAh at 11.1V, rated 90C, on 10AWG leads with an XT90 connector fitted. Suits larger electric cars, boats and aircraft.

At 7000mAh this is one of the bigger 3S packs available, so you run longer between changes. It is a long, low pack at 152 x 44 x 26mm and 425g — the length is the thing to check, since a bay that is deep enough may still be too short. Measure before ordering.

The 90C rating means the pack can be discharged hard without sagging under load — sharper throttle response, less power fade as the run goes on. The heavy 10AWG leads and XT90 plug back that up: both are sized for high current, so the delivery hardware matches what the cells can do rather than becoming the restriction.

Soft case construction keeps the weight down and flexes slightly into a tight tray, but the pack relies on your model's tray and strap for protection rather than a rigid shell, so make sure it's held securely.

Specifications

Voltage: 11.1V
Cells: 3S
Capacity: 7000mAh
Energy: 77.7Wh
Discharge rating: 90C
Connector: XT90
Wire gauge: 10AWG
Case type: Soft case
Length: 152mm
Width: 44mm
Height: 26mm
Weight: 425g
Application: Air / Boat / Car
Chemistry: Lithium Polymer (LiPo)

Needed to Complete

• A balance charger suitable for 3S LiPo packs. LiPo cells must be balance charged
• A LiPo charging bag or fireproof container is strongly recommended

Safe use. Charge on a non-flammable surface and never leave a LiPo charging unattended. Don't discharge below 3.0V per cell, don't charge a pack that's puffed or damaged, and store at around 3.8V per cell if it will sit unused.