The BSI303 Extra Long Extender Tip pushes thin and gap-filling CA exactly where you need it. At roughly 65mm, the rigid tip reaches into deep recesses, tight corners and assembled joints that a standard applicator tip can't get near — useful for tacking stringers inside a fuselage, running glue into a wing joint, or getting adhesive under a part that's already in position.

These fit over the #312 standard top — the one that comes on all BSI non-Pocket CA bottles — so if you're running BSI glue you're already set up. They resist clogging well, and when one does block up it can be cleaned by soaking in acetone rather than thrown away, which makes a pack of 24 last a long while on the bench.

Fitment and details

• Approx. 65mm tip length
• Fits over the Bob Smith Industries #312 standard top (supplied on all BSI non-Pocket CAs)
• Not suitable for BSI Pocket CAs — these use a different top
• Suits thin and gap-filling CA (cyanoacrylate / super glue)
• Extended rigid length for hard-to-reach and enclosed areas
• Clog-resistant — clean by soaking in acetone
• Pack of 24 tips